Opex Falcon - Page 71

71
Falcon User Manual - Remittance Processing - OPEX Corporation
Scheme 1 Mapping for “Generic” jobs
If the job’s General Job Parameters > Job Type parameter is set to Generic, the
keys are mapped as follows:
Scheme 1 Mapping for “WholesaleWorks” jobs
If the job’s General Job Parameters > Job Type parameter is set to either
WholesaleWorks Generic or WholesaleWorks Specific, the keys are mapped as
follows. Note that the presence and contents of “Tab0” and “Tab1” are dictated
by the ScanLink plug-in used by the job in question:
Key Function
1-8
selects page types 1 through 8
(and page sub-types 1-8, when the sub-type dialog is displayed)
9 Solicit Custom Data ScanLink Call
0 selects a new transaction
+ starts/stops the track
/ rotates the piece 90 degrees clockwise
* rotates the piece 180 degrees
-
flips the front and back images
(if the page type is set up to scan front and back images)
Key Function
1-8
selects page types 1 through 8
(and page sub-types 1-8, when the sub-type dialog is displayed)
9 Solicit Custom Data ScanLink Call
0 selects a new transaction
+ starts/stops the track
/ no action
* Toggle popup of “Tab 0”
- Toggle popup of “Tab 1”