Opex Falcon - Page 72

72
Falcon User Manual - Remittance Processing - OPEX Corporation
Scheme 2 Mapping for “Generic” jobs
If the job’s General Job Parameters > Job Type parameter is set to Generic, the
keys are mapped as follows (Note that some mapping are double presses. For
example, 0,1 indicates pressing 0 and then 1 in quick succession):
Scheme 2 Mapping for “WholesaleWorks” jobs
If the job’s General Job Parameters > Job Type parameter is set to either
WholesaleWorks Generic or WholesaleWorks Specific, the keys are mapped as
follows. Note that the presence and contents of “Tab0” and “Tab1” are dictated
by the ScanLink plug-in used by the job in question (Note that some mapping
are double presses. For example, 0,1 indicates pressing 0 and then 1 in quick
succession):
Key Function
0,1 -
1,2
selects page types 1 through 12
1 - 9 when the sub-type dialog is displayed, selects page sub-types 1-9
7,7 selects a new transaction
8,8 selects a new group
9,9 Solicit Custom Data ScanLink Call
+ starts/stops the track
/ rotates the piece 90 degrees clockwise
* rotates the piece 180 degrees
-
flips the front and back images
(if the page type is set up to scan front and back images)
Key Function
0,1 -
1,2
selects page types 1 through 12
1 - 9 when the sub-type dialog is displayed, selects page sub-types 1-9
7,7 selects a new transaction
8,8 selects a new group
9,9 Solicit Custom Data ScanLink Call