Opex FalconV - Page 57

Operation 57
FalconV User Manual - Standard Scanning - OPEX Corporation
Magnetic MICR
Read
Results of MICR region, as per pagetype configuration
Barcode Results
Results of Barcode 1 (same as Barcode 1 below, but
visible by default)
Barcode Results 1
Results of Barcode 1 (same as Barcode Results above, but
not visible by default)
Barcode Results
2-6
Results of Barcode 2-6, as per pagetype configuration
Marks Results
Indicates whether or not a mark was detected for those
marks defined in the pagetype
Bin Number Final destination of the selected piece.
Front Blank Page
Status
Indicates whether or not the front side of the selected item
was judged blank. Also states what % of pixels were filled.
Back Blank Page
Status
Indicates whether or not the back side of the selected item
was judged blank. Also indicates what percentage of pixels
were filled.
Page Ref ID 1
Page RefID. Visible in RunScreen if RefID #1 is defined in
Job. Always visible in Batch Editor.
Page Ref ID 2
Page RefID. Visible in RunScreen if RefID #2 is defined in
Job. Always visible in Batch Editor.
Page Ref ID 3
Page RefID. Visible in RunScreen if RefID #3 is defined in
Job. Always visible in Batch Editor.
Processing Time
Used
Percentage of allowable time used for this piece. Allowable
time is a function of track speed.
Unique Piece ID Ordinal number per execution. Used mainly for diagnosis.
Table 5: Page Information - detailed view
Parameter Description