Operation 77
FalconV User Manual - Standard Scanning - OPEX Corporation
Deleting items from the batch
When the machine is stopped, you can delete items from the batch. Click the
Delete button to delete an item image.
Note: The Delete button will only be present if activated in the current job.
The action of the Delete button depends on the setting of the Allow Delete
batch parameter:
• If the parameter is set to Delete Last Item, you will only be able to delete the
most recently scanned item image from the batch. Press Delete to delete the
last image.
• If the Allow Delete parameter is set to Delete To End Of Batch, you can also
choose an item thumbnail and delete the selected item and all the items
scanned after the item. When the Delete button is pressed, the Confirm
Delete window (Figure 19) will appear.
Figure 19: Confirm delete
Note: It is not possible to delete a single item image from the middle of the
batch within CertainScan. If you need to delete an image from the middle
of the batch, you must also delete all the images to the end of the batch
as well.
Voiding items and sets
The void function allows the operator to mark a scanned item or set as invalid
by placing a VOID stamp over the item’s image(s). The void function can be
used to confirm that an item or set was scanned into the system and deemed
invalid.
Note: The Void buttons will only be present if activated in the batch
parameters.
To Next Page
Loading...
