OPTICOM 764 - Page 55

73 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Intersection Equipment Installation Instructions

55

Test Call

Test Call

Test Call

Select

Select

Select

Test

Test

Test

Test

Figure 13-2 Direction Submenu

Table of Contents

Default Chapter3
- Table of Contents3
1 About this Manual5
- Intended Use5
- Technical Support5
- Safety Messages and Safety Labels5
- Safety Considerations5
- Disposal of Device6
- FCC Statement6
2 Description7
3 Radio/Gps Unit Installation10
- Model 1010 Radio/Gps Unit Mounting Location Considerations10
  - Model 1010 Radio/Gps Unit Installation14
  - Model 1012 Radio Installation16
4 Powering the Phase Selector20
- Powering on 120 VAC 60 Hz20
- Powering on 24VDC20
5 Phase Selector Installation in Controller Cabinets with Existing Card Racks21
- Potential for Electrical Shock23
6 Phase Selector Installation in NEMA Cabinets Using 760 or 1040 Card Rack24
- Model 1045B Card Rack27
  - Model 1045 in IR Operation27
7 Model 755 Four Channel Adapter Card and Other Model Card Racks28
8 Radio/Gps Cable Connection29
9 Model 768 Auxiliary Interface Panel (AIP)30
- Auxiliary Interface Panel Installation31
- Green Sense Wiring33
- Confirmation Light Wiring34
  - Confirmation Light Wiring with Load Switch Interface34
  - Confirmation Light Wiring with Electromechanical Relay Interface36
- Connecting Existing Harnesses to the Model 768 Auxiliary Interface Panel38
- Additional Output Connections39
  - Turn Signal Dependant Operation Example42
10 Infrared (IR) Operation43
11 Phase Selector Pin Index44
12 Communication Ports46
- Ethernet Port46
  - Ethernet Indicators46
- USB Port47
- RS-232 Communication Ports47
  - RS-232 COM Port on the Rear Edge Connector49
  - RS-232 COM Ports on the Auxiliary Interface Panel50
13 Phase Selector Indicators, Display and Switches51
- Indicators51
- Display and Switches53
14 Checkout58
15 Troubleshooting58
- Fuse Locations58
- Troubleshooting Tables59
16 Maintenance63
17 Setup and Testing63
Appendix A: Opticom Output Connection Worksheet (High Priority Only)64
Appendix A1: Opticom Output Connection Worksheet (High & Low Priority)65
Appendix B: Driving a Relay from a Phase Selector66
Appendix C Gate Opener Card Rack68
- Gate Opener Card Rack Installation69
  - Gate Opener Relay Outputs71