EasyManua.ls Logo

OPTICOM 764 - 16 Maintenance; Recommended Maintenance Procedures; 17 Setup and Testing; GPS;IR Mode Setup and Mapping

OPTICOM 764
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Intersection Equipment Installation Instructions
63
16 Maintenance
Opticom™ GPS System components are designed for reliable operation. Inspect the components at regular
intervals to ensure proper system operation.
GTT recommends the following:
All components should be inspected at least every twelve months.
Verify that radios are broadcasting using the On-site software.
Each intersection and vehicle system should be inspected and tested at least every twelve months to
ensure that it functions to your specifications and requirements.
Intersection systems should be tested with known good vehicle systems.
Vehicle systems should be tested with known good intersection systems.
You should develop a test plan that fits your department’s operations and meets the needs of your
system.
You should keep accurate and up-to-date records of system performance and test results.
17 Setup and Testing
1. If you are operating in GPS mode or simultaneous GPS/IR mode you will need to set-up and map the
phase selector before it will be operational.
2. It is recommended that a GTT trained technician or a GTT dealer perform the set-up and mapping.

Table of Contents