Opticon OPR 3001 - Curvature of Scan; 7 Technical Specifications; Figure 2: Laser Scanning Tilt and Curvature

Opticon
OPR 3001
Specifications Manual
11
6.1.2. Curvature of Scan
Maximum gap between the straight line connecting both ends of the laser scan
line and the actual laser scan line: Less than 1.27° curvature from the scan origin.
Maximum of 3.3 mm curvature when measured at a point 150 mm away from the
scan origin. (The skew angle of this measurement was zero degrees.)
• Measurement was done from the center of the scan origin.
Figure 2: Laser scanning tilt and curvature
7. Technical Specifications
The conditions for technical specifications are as follows, unless otherwise specified in each
section.
Conditions
Ambient temperature
and humidity:
Room temperature (5 to 35º C)
Room humidity (45% to 85% RH)
Ambient light: 500 to 900 lx
Angles: Omni-scanning mode: Pitch: α = 0°, Skew: β = 0–10°, Tilt: γ = 0°
Mobile mode: Pitch: α = 0°, Skew: β = 0°, Tilt: γ = 0°
Background: Barcode = black
Space = white
Margin = white
Background of label = black
Power supply voltage: 6.0 V (RS-232C) / 5.0 V (USB and Wedge)
Decoding test: Approve the performance when decoding is successful in all ten tests.
(Decoding is deemed successful when completed in 0.5 seconds or less.)