Opticum HD X406p - Motorized Antenna Setup

19
4.2.4 Antenna Settings for Motor
Menu-> INTALLATION ->Antenna Settings->Motor
1. Motor Mode:
Select DiSEqC 1.2 or USALS using
the VOL+/VOL- button.
DiSEqC 1.2: General motor
antenna using DiSEqC 1.2.
USALS: Motor antenna using
USALS system.
 Move Auto[W/E]
Press VOL+/VOL- button, the dish will be motorized to East/West continuously, it
will stop until it find the best signal.
 Move west-east
Press VOL+/VOL- button, the dish will be motorized to East/West step by step, until
you find the best signal showed on the signal bar.
 Fine Tuning(1)
Input digital button to set the moving step
 Store Position
Save the current position you searched.
 Go to Position
Press OK button to move the dish to the position which you saved.