To Apply Labels to Server Nodes and Storage Shelves
68 Oracle Database Appliance Owner's Guide • March 2017
See your rack documentation for detailed instructions for the following steps.
1.
Open and remove the front and rear doors from the rack cabinet.
Note - The front and rear doors need to be removed only if they interfere with the installation.
2.
To prevent the rack cabinet from tipping during the installation, fully extend the
rack cabinet's anti-tilt legs or anti-tilt bar, which are located at the bottom front of
the rack cabinet.
3.
If there are leveling feet beneath the rack cabinet to prevent it from rolling,
extend these leveling feet fully downward to the floor.
Applying Labels
Oracle Database Appliance X3-2, Oracle Database Appliance X4-2, Oracle Database Appliance
X5-2 and Oracle Database Appliance X6-2-HA are shipped with a label kit that provides four
labels, to be applied to the front of each server node and storage shelf.
To Apply Labels to Server Nodes and Storage Shelves
1.
Find the labels.
Depending on your model, the shipping kit might include server node labels and a sheet with
storage shelve labels.
■
Oracle Database Appliance X5-2 and Oracle Database Appliance X6-2-HA systems only
include server node labels to attach. The storage shelf labels are attached at the factory.
■
Oracle Database Appliance X3-2 and Oracle Database Appliance X4-2 systems include
both server node and storage shelf labels that you need to attach.
2.
Verify that the locations where the labels need to go are clean, and free of grease
and dirt.
3.
Apply the labels where needed:
For labels that you attach, peel off the backing sheet and apply the label to the corresponding
spot on the right-hand side of the appliance front panel.
■
Server Node 1: Apply this label to the top server node [1].
■
Server Node 0: Apply this label to the lower server node [2].
■
Storage shelf: Apply this label to the storage shelf directly beneath server node 0 [3].
To Next Page
Loading...
Need help?
General