Oracle SPARC T8-1 - Page 44

Attach the CMA to the Server
a.
Align connector C with the slide rail so that the locking spring (callout 1) is
positioned inside (server side) of the right slide rail (panel 1).
No. Description
1 Connector C locking spring
b.
Insert connector C into the right slide rail until it locks into place with an
audible click (panels 2 and 3).
c.
Gently tug on the right side of the CMA's rear slide bar to verify that
connector C is properly seated.
7.
Prepare the CMA's connector D for installation.
44 SPARC T8-1 Server Installation Guide • June 2019