Attach the CMA to the Server
Note - The slide rail latching bracket has a green release tab. This tab is used to release and
remove the latching bracket so that you can remove connector D.
9.
Gently tug on the left side of the CMA's slide bar to verify that connector D is
properly seated.
Note - The slide rail latching bracket has a green release tab. This tab is used to release and
remove the latching bracket so that you can remove connector D.
10.
Gently tug on the four CMA connection points to ensure that the CMA
connectors are fully seated before you allow the CMA to hang by its own weight.
11.
Verify that the slide rails and CMA operate properly.
See “Verify Operation of Slide Rails and CMA” on page 47.
Related Information
■
“Prepare the CMA for Installation” on page 38
■
“Secure Cables to the CMA” on page 60
46 SPARC T8-1 Server Installation Guide • June 2019
To Next Page
Loading...
