ST 9100 - HARDWARE GUIDE
3 COMPLIANCE & CERTIFICATION
Inmarsat Type Approval
Industry Canada
F
CC
Ingress Protection
l Cellular antenna: IP65
l Satellite antenna: IP67
l Transceiver unit: IP67
RoHS
Restriction of Hazardous Substances (RoHS)
1
UN
l UN 38.3 Transportation Compliance
PTCRB
EU RED 2014/53/EU
Here
by, ORBCOMM Inc. declares that the radio equipment types listed in this document comply with Directive
2014/53/EU.
The full text of the EU declaration of conformity is available from http://www2.orbcomm.com/eudoc.
1
European Union's (EU) Directive 2002/95/EEC "Restriction of Hazardous Substances" (RoHS) in Electronic and Electrical
Equipment.
T413, Version 0.04 BETA © ORBCOMM
®
Proprietary
38
l ICES-003
l RSS-170, Issue 2, Spectrum Management and Telecommunications Policy, Radio Standard
l RSS-102, radiation safety per Safety Code 6 (compliance shown by computation)
l IC ID: 11881A-ST9100; 11881A-UNNB30; 8595A-TOBYL280 or 8595A-1EHM44NN
l CFR 47 Part 25, CFR 47 Part 15
l CONTAINS FCC ID: XGS-ST9100; XGS-UNNB30; XPYTOBYL280 or XPY1EHM44NN
Warning
Other Certificate
l IEC60945; Anatel, ACMA, ICASA,
• The minimum 20cm separation distance from the device is required for RF exposure safety for all
persons.
• Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
• This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:(1)This device may not cause interference.(2)This device must accept any interference,
including interference that may cause undesired operation of the device.
• L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
To Next Page
Loading...
Need help?
General