Unit 6, Hawarden Industrial Park,
Hawarden
, CH5 3US, United Kingdom
Tel: +44 (0) 1244 670 900
Fax: +44 (0) 1244 539 301
Email:
ukinfo@csagroup.org
Web:
www.csagroupuk.org
SCHEDULE
EC TYPE-EXAMINATION CERTIFICATE
Sira 12ATEX3066
Issue 5
This certificate and its schedules may only be
reproduced in its entirety and without change.
Page 3 of 4
Form 9400 Issue2
ii. Issue 3 of the certificate introduced the Type 200cd setup, which is now included in original
temperature range table.
iii. It was recognised that these devices can have up to two M16, M20, M25, 1/2” NPT or 3/8” NPT
cable entries located in the underside of the Lighting Fixture base.
iv. The introduction of alternative methods of securing the dome lens in the Lighting Fixture for the
original and recessed versions was recognised.
v. Following appropriate re-assessment, the previous standard EN 60079-0:2009 was replaced by
EN 60079-0:2012.
Variation 5 - This variation introduced the following changes:
i. Typographical errors on previously certified drawings were corrected by changing the specification
of the original sealing ring material.
ii. The use of an alternative, silicone rubber sealing rings was recognised.
iii. The manufacturer requested that -50°C, +40°C and +45°C ambient temperature options should be
removed from the marking section as they are no longer required, however, they have been left in
the Description of Equipment to maintain the history of the product.
iv. Following appropriate assessment to demonstrate compliance with the latest technical knowledge, EN
60079-18:2009 was replaced by EN 60079-18:2015.
14 DESCRIPTIVE DOCUMENTS
14.1 Drawings
Refer to Certificate Annexe.
14.2 Associated Sira Reports and Certificate History
Issue Date Report no. Comment
0 13 June 2012 R25524A/00 The release of the prime certificate.
1 07 May 2013 R29038A/00 The introduction of Variation 1.
2 15 May 2013 R29079A/00 The introduction of Variation 2.
3 21 May 2013 R29185A/00 The introduction of Variation 3.
4 06 February 2015 R70005155A The introduction of Variation 4.
5 16 February 2016 R70044202A The introduction of Variation 5.
15 SPECIAL CONDITIONS FOR SAFE USE (denoted by X after the certificate number)
None.
16 ESSENTIAL HEALTH AND SAFETY REQUIREMENTS OF ANNEX II (EHSRs)
The relevant EHSRs that are not addressed by the standards listed in this certificate have been
identified and individually assessed in the reports listed in Section 14.2.
17 CONDITIONS OF CERTIFICATION
17.1 The use of this certificate is subject to the Regulations Applicable to Holders of Sira Certificates.
17.2 Holders of EC type-examination certificates are required to comply with the production control
requirements defined in Article 8 of directive 94/9/EC.
17.3 A visual inspection of the encapsulation is to be completed; no damage such as cracks, exposure of
encapsulated parts, flaking, inadmissible shrinkage, swelling, decomposition failure of adhesion or
softening shall be evident.
To Next Page
Loading...