Otto Bock The Back - Safety Instructions; Symbol Legend; General Safety Instructions

Safety Instructions
„The Back“ Ottobock | 21
1.4 CE Conformity
This product meets the requirements of the 93/42/EWG guidelines for medical products. This
product has been classied as a class I product according to the classication criteria outlined
in appendix IX of the guidelines. The declaration of conformity was therefore created by Otto
Bock with sole responsibility according to appendix VII of the guidelines.
1.5 Trademarks
All denotations within this accompanying document are subject to the provisions of the respective
applicable trademark laws and the rights of the respective owners, with no restrictions.
All brands, trade names or company names may be registered trademarks and are subject to
the rights of the respective owners.
Should trademarks in this accompanying document fail to be explicitly identied as such, this
does not justify the conclusion that the denotation in question is free of third-party rights.
1.6 Tools Required
• Phillips head screwdriver
• Soft-headed hammer: optional width adjustment
• Drill bit 6 mm (1/4"), for use when attaching optional headrest
1.7 Preparing the Wheelchair
Remove the back upholstery from the wheelchair and reattach the push handles according to
the manufacturer’s specications.
2 Safety Instructions
2.1 Symbol Legend
Danger!
Warning regarding possible risks of accident or injury.
Attention!
Warning regarding possible technical damages.
Note!
Information for operating the product.
Note!
Information for service personnel.
Attention!
Please read the Instructions for Use rst!