OTTO 1 00 Fast Charger • OMM- 000037 • REV. H
20
© Clearpath Robotics Inc. 2020. All rights reserved. CLEARPATH and OTTO are trademarks of Clearpath Robotics Inc. All other product and company names listed are trademarks
or trade names of their respective companies. The information contained in these documents is the Confidential and/or Proprietary property of Clearpath Robotics Inc. and may not
be duplicated, reproduced or further disclosed without the express written approval of Clearpath Robotics Inc.
6 PRODUCT SAFETY
6.1 Important Notes
• Read all instructions before using this product.
• Familiarize yourself with the System Specifications in the System Overview.
• Charger installation requires an electrically qualified person. Take note of this safety section and
local electrical codes before operation. Users are responsible for conducting their own safety
evaluation of the charge system and enforcing their own policies.
• OTTO Motors recommends adequately marking OTTO charging and docking zones for the hazards
presented and restricting access.
Charger users should follow the instructions contained in the operation and maintenance manual that
accompanies their OTTO 100 self-driving vehicle (SDV).
6.2 Hazards
This charger presents a number of risks to users even during the course of normal operation. All users
should familiarize themselves with the potential hazards of the system to anticipate and avoid them.
The hazards currently identified are as follows:
Electrical Shock
This charger is powered by a high voltage 200 V to 600 V power system. Improper use or
maintenance may result in serious injury or death.
Installation should only be performed by an electrically qualified person.
Maintenance should only be performed by designated and qualified individuals.
Never attempt to open the main electrical enclosure or adjust any cabling to or from the
enclosures while the system is connected to power.
Follow the Lock-Out/Tag-Out procedures of the facility in which the charger is installed.
To Next Page
Loading...