Outback MATE - Page 111

111
DATE & TIME
SETUP/MATE/PAGE1----
mate code rev: 402
choose category:
CLOCK CNT GLOW PG2
SETUP/MATE/CLOCK----
Tu 12/10/02
4:00:22P
BACK DATE TIME
SETUP/MATE/PAGE1----
mate code rev: 350
choose category:
CLOCK CNT GLOW PG2
SETUP/MATE/PAGE1----
mate code rev: 402
choose category:
CLOCK CNT GLOW PG2
BACKLIGHT
SETUP/MATE/PAGE1----
mate code rev: 350
choose category:
CLOCK CNT GLOW PG2
SETUP/MATE/CNT------
contrast: 30%
BACK INC DEC
CONTRAST
SETUP/MATE/GLOW----
backlight controls
BACK LEVEL MODE TIME
SUMMARY
SETUP/MATE/PAGE1----
mate code rev: 402
choose category:
CLOCK CNT GLOW PG2
SETUP/MATE/PAGE2----
choose category:
PG1 SUMRY COMM MAIN
SETUP/MATE/SUMMARY-
summary control
BACK TYPE TIME MAIN
COMM
SETUP/MATE/COMM-----
choose category:
BACK REPOLL PC DEBUG
ADVANCED FX MENU
INVERTER
SETUP/MATE/PAGE2----
choose category:
PG1 SUMRY COMM PG3
MAIN----------------
6:54:42P
SUM STATUS SETUP ADV
ADV/SETTINGS/WARNING
changes made could
adversely eect
system performance
ADV/PASSWORD--------
enter the password:
132
ENTER INC DEC EXIT
ADV-----------------
choose device:
FX CC DC MATE
ADV/FX/PAGE1--------
choose category:
ADV INV CHGR PG2
ADV/FX/INVERTER—-P00
search 2 cycles
pulse length
DOWN INC DEC PORT
ADV/FX/INVERTER—-P00
search 30 cycles
pulse spacing
DOWN INC DEC PORT
ADV/FX/INVERTER—-P00
low battery 21.0 vdc
cut-out set point
DOWN INC DEC PORT
ADV/FX/INVERTER—-P00
search 6
sensitivity
DOWN INC DEC PORT
ADV/FX/INVERTER—-P00
low battery 25.0 vdc
cut-in set point
DOWN INC DEC PORT
ADV/FX/INVERTER—-P00
adjust 120 vac
output voltage
DOWN INC DEC PORT
ADV/FX/INVERTER—----
reset FX to factory
defaults
DOWN MORE
ADV/FX/INVERTER--P00
choose fx port
then press next
EXIT PORT NEXT
ADV/FX/INVERTER—-P00
press button 1
Ready
EXIT 1 2
ADV/FX/INVERTER--P00
press button 1
Done
EXIT 1 2
ADV/FX/INVERTER—----
reset FX to factory
defaults
DOWN MORE
ADV/FX/INVERTER—----
inverter programming
completed
TOP ADV MAIN
ADV/FX/INVERTER—-P00
press button 2
Ready
EXIT 1 2