Need help?Do you have a question about the Outback MATE and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Operating Temperature Range | -20°C to 60°C |
| Mounting | Wall Mount |
| Type | System Display and Controller |
| Communication | RS232 |
| Communication Ports | RS232 |
Provides a visual overview of the MATE unit's components and interface.
Explains the primary functions and purpose of the MATE system controller.
Provides instructions for physically mounting and connecting the MATE device.
Details the sequence of screens displayed when the MATE powers up.
Explains how to navigate menus and use soft keys for operation.
Guides through the initial setup process for the MATE controller.
Explains how to set the MATE's internal clock and calendar functions.
Details how to adjust the screen contrast for better readability.
Guides on adjusting the screen backlight brightness and mode.
Explains how to manage MATE communication settings and options.
Provides guidance on diagnosing and resolving communication issues.
Describes how to access and view system summary screens.
Details summary screens for FX and Charge Controller status.
Covers options for customizing the display and timing of summary screens.
Introduces status screens for viewing component activities and meters.
Explains how to interpret information displayed on status screens.
Details FX modes, meters, battery, errors, warnings, disconnect, and sell screens.
Details CC modes, meters, and set points.
Explains how to use the INV hot key for direct control of the FX inverter.
Details how to use the AC IN hot key for controlling AC input source connection.
Covers GEN START CONTROL and CHARGER CONTROL screens.
Details the EQUALIZE CONTROL screen for performing equalization charging.
Introduces advanced MATE controls for system configuration and optimization.
Guides on accessing the MATE's advanced settings menu, including password entry.
Explains HBX Mode for controlling grid-supplied power based on battery voltage and time.
Covers AGS Mode, AGS Port, and settings like Quiet Time, Voltage Start, Load Start, Must Run, % SOC, Generator Exercise.
Explains Grid-Use Mode for managing grid AC power connections based on time.
Explains the branching menu structure of the MATE system.
Lists categories of screens for MATE, FX, CC, and FLEXnet DC.
Provides an overview of common user tasks and programming routines.
Guides on setting limits for battery recharging via FX and HBX modes.
Details connecting to grid and configuring automatic generator start.
Guides on configuring multiple FX Series Inverter/Chargers for stacking.
Solutions for MATE power-up and device detection problems.
Solutions for incorrect meter display and EQ function issues.
Troubleshooting steps for MATE communication errors.
Section for recording system installation and battery charging details.
Details on purchasing an extended warranty for the product.
To Next Page
