Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 26OM2010_GB
2.9. RISKS, PROTECTIONS, WARNINGS, CAUTIONS
In the designing phase all parts and areas subject to risks have been evaluated and all
necessary precautions have been taken consequently to avoid any risks to persons and
damages to the machine components as indicated in the previous paragraphs.
ATTENTION
PERIODICALLY CHECK ALL SAFETY DEVICES FUNCTIONING.
DO NOT REMOVE THE FIXED OR MOBILE PROTECTIONS FROM
THE MACHINE.
DO NOT INTRODUCE EXTRA OBJECTS OR EQUIPMENTS IN THE
MACHINE WORKING AREA.
Although the machine is equipped with the safety systems mentioned above, some risks
which can not be eliminated still remain and are reducible by means of corrective
actions and correct mandatory operating modes for anyone operating on the machine.
Here below a summary of the risks remaining in the machine during:
• Normal functioning
• Adjusting and start-up
• Maintenance
• Cleaning
2.9.1. Danger for the operator
During the normal use of the machine, the operator doesn’t risk any danger, since the
movements whch can cause risks conditions are controlled by the electro-mechanic sy-
stem installed in the machine.
The risks related to:
• operator disattention,
• non-compliance with the information and instructions contained in this manual,
• deliberate tampering of the machine or of the safety devices,
• tampering of fi xed and movable guards,
these actions can not fi nd total intrinsic protection, due to the construction type of the
machine.
2.9.2. Residual risks generated by the elements under pressure
After pressing the emergency stop, all dangerous movements are depressurized, but all
hydraulic hoses and cylinders that hold loads, remain under pressure.
2.9.3. Residual risks during maintenance
During the machine maintenance, pay attention to avoid the risk to enjure:
• arms (abrasion on mechanical parts),
• legs (mechanical parts falling if not properly hold),
To Next Page
Loading...