Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 70OM5029_GB
5.3. DAILY CHECK
Before starting any intervention, set close the machine, engine off, disconnected from
the power source and possibly clean;
A DIRTY MACHINE DOES NOT ALLOW A CORRECT INSPECTION.
Check:
1. Absence of damage to the equipment due to transport; parts missing or damaged, oil
leaks, damaged tyres, disconnected cables
2. The engine oil level through the engine stick (see the engine manufacturer manual
attached) and the fuel level through the indicator Fig. 5.1
3. Depending from the installed indicator, check that: the hydraulic oil level reach the
middle of the optic signal when the machine is in transport position with the indicator
of Fig. 5.2a; or reach the MAX value of the indicator of Fig. 5.2b.
Fig. 5.2 a
Fig. 5.2 b
Fig. 5.1
To Next Page
Loading...