Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 28OM2010_GB
Ensure the operational areas, transit areas and emergency exits to be free from obstacles
and to fulfi l the compliance requirements.
2.9.7. Circuits failure
Because of possible faults, the circuits / control components, the safety components and
the power components can partially lose their effi cacy with a consequent lowering of
the security level:
• periodically check the functioning status of the machine devices/components.
2.9.8. Lightening
The operator must provide an adequate lighting system on the areas of maintenance of
the machine and comply with the local laws in force and according to the Directives.
In case of power failure, it is recommended an average illuminance of at least 400 lux.
If an ‘extra lighting is necessary, for exceptional rare maintenance operations, take into
account the character of extreme rarity of these cases and use safety portable lamps (po-
wered at 24 Vdc, not supplied with the machine).
Any ligthening is supplied with the machine
2.9.9. Risk of scalding/burn
Due to the temperature present on engines there is a potential risk of burn during the
normal use and in particular during their maintenance operations.
• Inform the maintenance staff about the maintenance activities or machine use.
• Access those areas waiting the above mentioned parts cooling before and with pro-
per protecting gloves, with the max attention.
2.9.10. Risks due to movement
The machine loading/unloading operations by means of lifting equpments,
from container to the box, expose the operators to the risks of suspended
loads or crush.
Those operations must be executed exclusivally by specialized staff for
lifting equipments use, properly trained on that scope.
ATTENTION
Before operating, read carefully chapter 3 of the manual
2.9.11. Risks for the exposed persons
The exposed persons are third persons not engaged in the machine operation, therefore
persons working near the machine or visitors.
During the machine use and maintenance, fence all the working area exposing eventual-
ly prohibiting plates
To Next Page
Loading...