Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 41OM3109_GB
3.7. PLATFORM SELFPROPELLING
To travel follow these instructions:
• Turn on the engine from the main desk (Part 1 Fig. 3.2/3.3)
• Turn the key of the commands selections (Part 2 Fig. 3.1) on turntable symbol
(central position)
• Activate the radio connection between transmitter and receiver (note on a fi g.3.4)
• Use the left and right joystick (Parti 1 e 6 Fig. 3.4) to control the track
• It is possible to rotate the machine on itself, actioning the two above mentioned
levers in opposite direction, one forward and the other backward
• transfer always with tracks in enlarged position. Use the narrow position only to
pass througth corridors or narrow spaces and fl at grounds
It is possible to intervene on the transfer speed of the equipment in two different ways:
1) increasing the rpm througth the selector 14 Fig. 3.4
2) actionning the selector 13 Fig. 3.4: in central position the speed is high, while on
the left side the tracks motors displacement is reduced
!
ATTENTION
It is forbidden to travel with people or loads in the basket.
!
ATTENTION
“Rabbit” option corresponds to the max speed and it’s for long transfer on
fl at grounds and free from obstacles.
“Snail” option corresponds to the min speed, which can be always switched
to the fast speed, and it’s for transfer on slopes, indoor or on paths with ob-
stacles (i.e. inside a workshop or a museum, etc).
IMPORTANT
Climb slopes up and down with the boom upstream and slow down on bum-
ps overcoming, to avoid strong oscillations of the boom
IMPORTANT
During transfer in an area opened to traffi c, it is necessary to install a “wor-
king site” with fi ends and tools, to avoid collisions when the machine is not
equipped with signaling devices
To Next Page
Loading...