Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 27OM2010_GB
• eyes (dangers generated by pression fl ows and elements in tension),
• head (hit with some machine parts).
Read the description in paragraph 2.9.2 carefully, most of all regarding the elements
remaining under pressure with the pneumatic energy sectioned
.
SHOCK HAZARD
During the troubleshooting or during a maintenance operation, make
sure the machine is not connected to electricity, because the risk of
electric shock can be caused by direct contact or by indirect contact.
ATTENTION
Before plugging to electricity, be sure there’s no maintenance intervention
on and anybody is operating with the machine
2.9.4. Explosive atmosphere
The machine is not designed to work in explosive or classifi ed environments. The ma-
chine is not suitable therefore to operate in areas:
• totally or partially exposive
• classifi ed
• with presence of corrosive atmosphere
• with presence of gas and/or powder concentrations
• with presence of oil concentrations high presence
• with burning risk related with any
• in cui siano presenti atmosfere corrosive
• in cui siano presenti alte concentrazioni di gas e/o polvere
• with fi re hazard arising from any material or source of ignition.
!
ATTENTION
It is strictly forbidden to use the machine in all above mentioned areas
2.9.5. Slipping
Possible lubricants leaking can cause the staff slipping
!
ATTENTION
Access those area with non-slip and always cleaned shoes; inspect them
periodically depending on usage.
2.9.6. Stumbeling
The not in order deposit of material can typically create a tripping hazard and limitate
the partial or total emergency exit in case of need.
To Next Page
Loading...