Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 48OM3109_GB
Fig. 3.11
3.13. AERIAL WORK
Access to the platform
!
ATTENTION
Do not start an aerial work without an assitant from the ground, whose
presence is compulsory to recover the cage to the ground in case of con-
trols system defeat.
DANGER
Operators must not exit and access from the cage from high position.
DANGER
Stay on the cage only for lifting and working in high position. During the
transfer, operators must not stay on board.
Protections don’t grant all risks from a possible overturn. If the light and the overloading
acoustic alarm activates, quickly download the exceeding load.
If the cage has to lift beyond an obstacle (river, diffi cult ground..) it is advisable to
try before with a similar weight (ie. 2 persons) and check if the boom reaches the
wished position without stopping.
After positioning the stabilisers on the ground and leveling the chariot, the machine is
ready for aerial work; the controls panel at the cage must be activated by means of the
proper selector, fi
rst (part 2 Fig. 3.1 left position).
IMPORTANT
Before performing any turntable movement, take the rotation locking pin
off Fig. 3.11
From the controls panel at the cage, the
boom movements are allowed. In fi g. 3.5 all
manoeuvres are indicated, with the relative
joysticks. It is, however, possible to activate
the controls of the aerial movement also
from a different position, with the proper
key (in case of maintenance, settings, trai-
ning course, etc.).
To Next Page
Loading...