Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 45OM3109_GB
g 3.7
To move the stabilizers without pins, follow this instructions:
• turn on the diesel motor
• move the key selector (Part 2 Fig. 3.1) to the “stabilizers” position (on the right)
• check the green light on the turntable, this means that the boom is in center po-
sition, lowered and retracted
• press the FN button on the desk (Part 9 Fig. 3.1) and in the same time move the
stabilizers like a normal situation (using the control proportional lever and the
stabilizers joysticks which must be moved).
3.12. LEVELLING THE MACHINE
Depending on the different needs, the stabili-
zers can be set-up on the ground with different
positions, rotating their supports which con-
nect them to the chassis. Once the desired posi-
tion is decided, the pins must be inserted in the
appropriate
holes and the locking pin of the above mentio-
ned supports to the chassis to manoeuvre the
boom (Fig. 3.7).
IMPORTANT
It’s important to consider the relationship between the working area and the
position of the stabilizers in order to stabilize the platform in the best way.
DANGER
In case of fl oors and basements, check if the slab capacity supports the
pressure on the stabilizer. This data is indicated in the sticker on every
stabilizer.
If possible, the best stabilizers set-up is always the larger one, which allows a more ho-
mogeneous working area over the 360°.
To Next Page
Loading...