Tel. 0039 030 6857073 - Fax 0039 030657079 info@palazzani.it - www.palazzani.it
Pag. 79OM5029_GB
5.9. EXTRAORDINARY MAINTENANCE
As described above, in hostile work conditions it may be necessary to anticipate the
programmed maintenance operations. For example, the saltiness damages on paint,
chains, cylinders stems; the wind, when carrying sand, may damage the hydraulic oil or
the command panels. It is also recommended not to leave the machine outside for a long
time: water may penetrate and damage electric equipment and cause rust formation.
In other situations too the operator must intervene immediately: pump replacement,
perforated tyres, damage of fl exible pipes, damage of batteries, weldings, etc ...
In case of battery damage we recommend the maximum care because the electrolyte is
dangerous for people and for the environment.
Wear glasses to avoid squirts into the eyes and wear glasses to avoid skin damage.
Use these protections also when treating oil. The oil acts as human fat solvent and a
constant exposition to it may cause dermatitis or serious irritation. In case of any contact
with the eyes rinse copiously with water and if the irritation persists, contact a doctor.
Moreover, before manipulating these products, read carefully the producer’s
recommendations about its usage.
Before welding, disconnect both the battery poles. Connect the mass onto the element
where you have to execute the soldering and never onto a hydraulic circuit element.
To Next Page
Loading...