- 152 -
This sets the blur amplitude of the Image Stabilizer during recording. (l 43)
This sets the blur frequency of the Image Stabilizer. (l 43)
You can assign ATW to the WHITE BAL switch.
This sets the control speed for ATW. (l 57)
This fine-adjusts the intensity of red. (l 57)
≥ This function’s default setting is “0”.
This fine-adjusts the intensity of blue. (l 57)
≥ This function’s default setting is “0”.
[BLUR AMPLITUDE]
[1]/[2]/[3]/[4]/[5]
[BLUR FREQUENCY]
[1]/[2]/[3]
[ATW SET]
[OFF]: Does not assign ATW to the WHITE BAL switch.
[Ach]: Sets the White Balance mode to ATW when the WHITE BAL switch is set to
A
.
[Bch]: Sets the White Balance mode to ATW when the WHITE BAL switch is set to
B
.
[PRST]: Sets the White Balance mode to ATW when the WHITE BAL switch is set to
PRST.
[ATW SPEED]
[FAST]/[NORMAL]/[SLOW]
[ATW TARGET R]
[ATW TARGET B]
To Next Page
Loading...
