- 61 -
Gain adjustment
≥ Use the jog dial to change the settings.
≥ Switch to Manual Mode. (l 36)
1 Slide the GAIN switch.
2 Adjust the gain by rotating the jog dial.
Gain value:
(When [GAIN/ISO DISPLAY CHG] (l 173) is set to [GAIN])
0dB to 24dB
≥ Value closer to 0dB darken the image.
≥ Value closer to 24dB brighten the image.
(When [GAIN/ISO DISPLAY CHG] is set to [ISO])
ISO500 to ISO8000
≥ Value closer to ISO500 darken the image.
≥ Value closer to ISO8000 brighten the image.
≥ Auto Gain Mode is activated when one of the following operations is performed:
j Setting [AGC] to [ON] and switching to Auto Mode
(l 36)
j Setting any of [LOW GAIN], [MID GAIN] and [HIGH GAIN] to [AUTO] and setting the GAIN
switch to the corresponding position.
A Gain value
≥ The gain value changes depending on [GAIN/ISO DISPLAY CHG] setting:
j (When set to [GAIN])
In Auto Gain Mode, “AGC” is displayed; in Manual Gain Mode, the gain value is displayed in
dB.
j (When set to [ISO])
In Auto Gain Mode, “ISO AUTO” is displayed; in Manual Gain Mode, the gain value is
displayed in ISO.
B [GAIN]
L: Sets the gain value to a value set in [LOW GAIN] (l 150).
M: Sets the gain value to a value set in [MID GAIN] (l 150).
H: Sets the gain value to a value set in [HIGH GAIN] (l 151).
To Next Page
Loading...
