- 62 -
≥ It is not possible to adjust the gain value using the GAIN switch and jog dial in the following
situations:
j During Freeze Frame (l 81)
≥ If the gain value is increased, the noise on the screen increases.
≥ In Auto Iris Mode or Auto Shutter Mode, the screen brightness may not change even if you adjust
the gain. (l 59, 63)
∫ Changing the maximum possible gain value for Auto Gain Mode
Select the menu.
(When [GAIN/ISO DISPLAY CHG] is set to [GAIN])
(When [GAIN/ISO DISPLAY CHG] is set to [ISO])
You can use Super Gain by registering [SUPER GAIN] to a USER button. Super Gain allows you to
set a Super Gain value.
Please refer to page 74 for details about setting the USER button.
≥ Switch to Manual Mode. (l 36)
Press the USER button to which [SUPER GAIN] is registered or touch the
applicable USER button icon.
≥ To cancel Super gain, press the USER button or touch the USER button icon again.
∫ To change the gain value of Super Gain
Select the menu.
(When [GAIN/ISO DISPLAY CHG] is set to [GAIN])
(When [GAIN/ISO DISPLAY CHG] is set to [ISO])
≥ Super Gain is not available in the following cases:
j In Auto Gain Mode
j During Freeze Frame (l 81)
j In High-sensitivity Recording Mode (l 148)
: [AUTO SW] # [AGC LIMIT] # desired setting
[3 dB]/[6 dB]/[9 dB]/[12 dB]/[15 dB]/[18 dB]/[21 dB]/[24 dB]
[ISO1000]/[ISO2000]/[ISO4000]/[ISO8000]
Super Gain
[GAIN/ISO DISPLAY CHG] (l 173) setting Gain value in Super Gain
[GAIN] [30 dB] or [36 dB]
[ISO] [ISO16000] or [ISO32000]
: [SW SETUP] # [SUPER GAIN] # desired setting
[30 dB]/[36 dB]
[ISO16000]/[ISO32000]
To Next Page
Loading...
