- 74 -
≥ [TCG] will be set to [FREE RUN].
5 (On the slave device)
Press the RESET/TC SET button.
≥ [TC LINK OK] will be displayed and the time code will be synchronized with that of the master
device.
≥ When the time code is not synchronized correctly, [TC LINK NG] is displayed.
≥ To cancel the operation without synchronizing the time code, touch [EXIT].
≥ Use a commercially-available, double-shielded BNC cable equivalent to 5C-FB.
≥ [EXT TC LINK] cannot be set to [SLAVE] in the following cases:
j In Variable Frame Rate Mode (l 91)
j During the Interval Recording (l 162)
Each of the USER button can register one function from the 38 available functions.
≥ There are eight USER buttons (USER1 to USER8) on the main body and four USER button icons
(USER9 to USER12) displayed on the LCD monitor.
Setting the USER button
1 Select the menu.
≥ It is not possible to register functions to [USER9] to [USER12] in Playback Mode.
2 Touch the item to register.
≥ For the functions of the USER button that can be registered, refer to page 76.
≥ Touch [INHIBIT] if not registering.
≥ Next (Previous) page can be displayed by touching / .
3 Touch [EXIT] to complete the setting.
≥ The tables below show the default settings.
≥ Performing [ALL] in [INITIAL SET] restores these default settings. (l 178)
: [RECORD SETUP] # [EXT TC LINK] # [SLAVE]
Recording
USER button
: [USER SW] # [USER1] to [USER12]
USER1 button [DRS] USER7 button [WFM]
USER2 button [ATW] USER8 button [REC CHECK]
USER3 button [BACKLIGHT] USER9 button [FRZ FRAME]
USER4 button [FOCUS MACRO] USER10 button [EVF/LCD DETAIL]
USER5 button [O.I.S.] USER11 button [ATW LOCK]
USER6 button [ZEBRA] USER12 button [MENU]
MENU
To Next Page