- 72 -
You can set the initial time code.
1 Select the menu.
2 Touch the item to set and change with / .
≥ It will be set to 00h00m00s00f when the RESET/TC SET button is pressed.
≥ “h” is an abbreviation for hour, “m” for minute, “s” for second and “f” for frame.
3 Touch [EXIT] to complete the setting.
≥ This unit will adjust the time code in accordance with the frame rate of the [REC FORMAT]
(l 142) or [OUTPUT FORMAT] (l 147). Therefore, it may not be continuous from the previous
final time code when the recording format is changed.
≥ If the frame rate in [REC FORMAT] or [OUTPUT FORMAT] is set to 23.98p, set the number of
frames to [00] or a multiple of 4. If you enter a different value, time code will not be recorded
correctly.
Setting the User Information
Eight digit hexadecimal alphanumeric can be entered and displayed as a memo information such as
dates, control numbers, etc., into the User Information.
UB 00 00 00 00
≥ This is displayed only when [REC MODE] is set to [AVCHD]. (l 141)
You can set the User Information.
≥ Set [REC MODE] to [AVCHD]. (l 141)
1 Select the menu.
2 Touch the item to set and change with / .
≥ You can use numbers from 0 to 9 and letters from A to F.
≥ It will be set to 00 00 00 00 when the RESET/TC SET button is pressed.
3 Touch [EXIT] to complete the setting.
[TC PRESET]
: [RECORD SETUP] # [TC PRESET]
[UB PRESET]
: [RECORD SETUP] # [UB PRESET]
MENU
MENU
To Next Page
Loading...
