- 71 -
Select the compensation mode for the time code.
≥ Set [SYSTEM FREQ] to [59.94Hz]. (l 141)
Select the menu.
≥ This item will be set to [NDF] automatically in following cases:
j When the frame rate in [REC FORMAT] or [OUTPUT FORMAT] is 23.98p or 24.00p (l 142,
147)
j During the Interval Recording (l 162)
≥ This item will be automatically set to [NDF] and will not be displayed as a menu item when
[SYSTEM FREQ] is set to [50.00Hz]. (l 141)
Sets the way the time code will move.
Select the menu.
*1 If the frame rate in [REC FORMAT] or [OUTPUT FORMAT] is set to 23.98p, a slight time error
may occur when switching to Playback Mode. (l 142, 147)
≥ It is automatically set to [FREE RUN] in following cases:
j When PRE-REC is enabled (l 86, 163)
j When [2 SLOTS FUNC.] is set to [BACKGROUND] (l 159)
≥ It is automatically set to [REC RUN] in following cases:
j In Variable Frame Rate Mode*
2
(l 91)
j During the Interval Recording (l 162)
*2 [FREE RUN] is also available if the number of frames for the frame rate in [REC FORMAT] and
the number of frames for Variable Frame Rate Mode are the same.
Example: When [REC FORMAT] is set to [FHD 1080/59.94p 50M] and the frame rate is set to
[60]
≥ The time code will reset when the built-in lithium battery is exhausted when it is set to
[FREE RUN].
[DF MODE]
: [RECORD SETUP] # [DF MODE] # desired setting
[DF]: Time code is compensated in accordance with the actual time. It is
mainly used for broadcasting such as TV programs.
[NDF]: It will not compensate the time code. (There will be a difference from
the actual time)
[TCG]
: [RECORD SETUP] # [TCG] # desired setting
[FREE RUN]*
1
: It will constantly move.
[REC RUN]: It will move only when recording.
MENU
MENU
To Next Page
Loading...
