- 53 -
≥ Select the [FOCUS TRANSITION] menu. (l 52)
≥ Register [FOCUS TRANS] to a USER button. (l 74)
1 Switch to Manual Focus Mode. (l 44)
2 Press the USER button to which [FOCUS TRANSITION] is registered or touch
the applicable USER button icon.
3 Touch a registered item ([1]s[3]).
≥ Focus Transition will start. Focus will shift slowly from the
current position to the registered position. This will take a
few seconds. (l 54)
≥ As the focus shifts, the Focus Transition bar will move
from [S] to [E].
4 Touch [EXIT] to exit Focus Transition.
≥ If you move this unit a lot after setting the focus position, focus may not stop at the set position.
≥ When Focus Transition is in use, focus cannot be adjusted with the focus ring.
≥ Focus Transition is not available in the following cases:
j When Auto Focus is used
j During Freeze Frame (l 81)
j In Variable Frame Rate Mode (l 91)
j When color bars are displayed. (l 95)
j When a remote control (commercially-available) is connected (l 113 )
≥ Focus Transition settings are canceled in the following cases. To use Focus Transition again,
register a focus position again. (l 52)
j If you operate the zoom
j If you enable or disable Infrared Recording Mode
≥ You can only use the following USER button functions by pressing one of the USER buttons 5
s8
when Focus Transition is in use (l 74):
j [FOCUS ASSIST]
j [FOCUS TRANSITION]
j [INFRARED REC]
j [BACKGROUND]
j [PRE-REC]
j [EVF ON/OFF]
j [AUTO REC]
j [MENU]
Using Focus Transition
SE
1
2
3
MF50MF50
A [EXIT]
B Focus Transition bar
To Next Page
Loading...
