- 58 -
Setting the White Balance mode to [VAR] allows you to set a White Balance value between P2000K
and P15000K.
≥ Use the jog dial to change the settings.
≥ Switch to Manual Mode. (l 36)
1 Set the White Balance mode to [VAR]. (l 55)
2 Rotate the jog dial to adjust the color balance.
3 Push the jog dial to
finish the adjustment.
≥ You can also access this setting by selecting menu items.
[SW SETUP] # [WB VAR] (l 153)
1 Fill the screen with a white subject or place a white piece of paper in front of
the lens.
2 Set the WHITE BAL switch to A or B.
≥ The White Balance mode will be set to [Ach] or [Bch].
3 Press and hold the AWB button to set Auto White Balance.
≥ Adjust the Black Balance first, and then the White Balance. The screen goes dark momentarily,
“WB SET OK” is displayed, and the adjustment ends.
≥ If you have pressed the AWB button, only the White Balance can be adjusted. When
“WB SET OK” is displayed, the adjustment is complete.
≥ When the mode of White Balance is set to something other than [Ach] or [Bch], the Auto Black
Balance is performed by pressing and holding the AWB button. Setting is completed when the
screen goes black momentarily and “BB SET OK” is displayed.
≥ When the Auto White Balance/Auto Black Balance cannot be performed, an error message
“WB SET NG” or “BB SET NG” is displayed on the screen. In such case, use other mode.
≥ The contents previously set are maintained in the [Ach] or [Bch]. Perform the setting again when
the recording condition has changed.
To finely adjust the White Balance
To set the White Balance in accordance to the recording scene
To Next Page
Loading...
