• When [Multicast] is enabled, [Multicast] becomes available in the [Streaming Method] selector on the
single camera page.
8. Under [Packet Availability Time], enter the desired setting.
9. Under [Multicast (IPv4)], check [Use] to enable multicasting for IPv4. If used, the following settings are also
necessary.
a. Enter the IP address of the multicast.
b. Enter the first port number to be used for MPEG-4 streaming. This port number must be an even
number.
c. Enter the port number to be used for audio streaming. This port number must be an even number.
10. Under [Multicast (IPv6)], check [Use] to enable multicasting for IPv6. If used, the following settings are also
necessary.
a. Enter the IP address of the multicast. This address must be an IPv6 address.
100 Operating Instructions
5.7 Changing Video Streaming Settings
To Next Page
Loading...
