8.4 Confirming Alarm Logs
You can view information about the last 50 image buffer triggers on the [Alarm Log] page.
1. Click the [Maintenance] tab.
2. On the left side of the screen under [Maintenance], click [Alarm Log].
3. Confirm the desired information.
Note
• When the camera is restarted, the alarm log content is deleted.
• You can configure the camera to send a daily log by E-mail that reports the status of triggers 1–5 (see
Page 59).
122 Operating Instructions
8.4 Confirming Alarm Logs
To Next Page
Loading...
