2.10 Sending Alarm Log Information
You can configure the camera to send a daily log by E-mail that reports the status of the sensor and motion
detection triggers. This allows you to be notified by E-mail once a day and know whether or not there were any
events that triggered the camera. Ask your Internet Service Provider (ISP) or network administrator for the
appropriate settings.
1. Click the [Setup] tab.
2. On the left side of the screen under [Buffer/Transfer], click [Alarm Log].
3. Under [A setup of operation], select the desired setting.
– [Never send alarm logs]: Alarm logs will not be sent.
– [Always send alarm logs]: Alarm logs will be sent, even if the camera was not triggered.
– [Send alarm logs only when the camera was triggered]: Alarm logs will be sent if the camera was
triggered.
– [Send alarm logs only when the camera was not triggered]: Alarm logs will be sent only if the camera
was not triggered.
4. Under [Active Time], select the days and the time you want the camera to send alarm logs.
Operating Instructions 59
2.10 Sending Alarm Log Information
To Next Page
Loading...
