8.9 Resetting the Camera
You can reset all of the camera’s settings to their factory default settings.
1. Click the [Maintenance] tab.
2. On the left side of the screen under [Maintenance], click [Reset To Factory Default].
3. Click [Execute].
• The indicator blinks orange, and then turns off for a few seconds.
Note
• Do not turn off the camera while the camera is being reset. When the lens finishes panning and tilting,
it is safe to turn off the camera.
• When the camera is reset, the following information will be deleted:
– All buffered images
– All alarm logs
– All camera settings (including the user name, password, IP address, subnet mask etc.)
The network connection mode changes to [Automatic Setup]. Reconfigure the camera by referring
to the [Setup Guide].
• When the camera is reset, the internal clock will not be reset, but the time format will be set to AM/PM
mode. Change the setting if necessary (see Page 95).
• See Page 149 for a list of the camera’s default settings.
Operating Instructions 127
8.9 Resetting the Camera
To Next Page
Loading...
