10.4 Accessing the Camera in IPv6 Mode
You will need to know the following information to access the camera in IPv6 mode.
• The URL assigned to you by the domain name service or Dynamic DNS service you registered the camera
to (e.g., bob.viewnetcam.com).
• The port number of the camera, if it is not 80.
• The user name and password required to access the camera, which were set during camera setup.
1. Start your PC’s web browser.
2. In the browser’s address bar, enter http:// followed by the IP address of the camera, then press
[Enter] on the keyboard.
Example: http://bob.viewnetcam.com
3. When the authentication dialog is displayed, enter the user name and password, then click [OK]. The top
page is displayed.
Note
• For general information on accessing the camera, see Page 7.
136 Operating Instructions
10.4 Accessing the Camera in IPv6 Mode
To Next Page
Loading...
