5.7 Changing Video Streaming Settings
The [Video Streaming] page of the [Setup] tab allows you to adjust video streaming feature-related settings.
1. Click the [Setup] tab.
2. On the left side of the screen under [Basic], click [Video Streaming].
3. Under [MPEG-4 Max. Frame Rate], select the number of frames per second the camera streams for each
resolution setting.
4. Under [MPEG-4 Bit Rate], select the minimum and maximum bit rate for each resolution setting.
5. Under [RTSP], enter the port number used for RTSP. (Usually port number 554 is used.)
6. Under [RTP], enter the first port number used for RTP.
• The port number above RTP is used for RTCP. For example, when port number 33000 is used for
RTP, port number 33001 is used for RTCP.
7. Under [Multicast], check [Multicast settings screen is displayed.] to configure the camera for multicasting,
otherwise click [Save] to finish.
Operating Instructions 99
5.7 Changing Video Streaming Settings
To Next Page
Loading...
