Panasonic BL-C111A - Network Camera - Pan - Creating a Shortcut to the Camera

11.2 Creating a Shortcut to the Camera
If you are using Windows XP, you can create a shortcut to the camera in your computer’s [My Network
Places] folder that will be automatically updated even if the camera’s IP address changes. In order to use this
feature, you must first enable the UPnP™ component of Windows XP using the following procedure.
Note
• Windows 2000 does not support this feature.
• This feature is enabled for the camera by default. You can confirm the setting on the [UPnP] page if
necessary (see Page 94).
When using Windows XP (Service Pack 2)
[Start]®([Settings])®[Control Panel]®[Add or Remove Programs]®
[Add/Remove Windows Components]®Select [Networking Services]®[Details]®
Check [Internet Gateway Device Discovery and Control Client] and [UPnP User Interface]®
[OK]®Complete
When using previous versions of Windows XP
[Start]®([Settings])®[Control Panel]®[Add or Remove Programs]®
[Add/Remove Windows Components]®Select [Networking Services]®
[Details]®Check [UPnP User Interface]®[OK]®[Next]®Complete
140 Operating Instructions
11.2 Creating a Shortcut to the Camera