1.2.3 Limiting the Pan/Tilt Range
You can limit the maximum pan and tilt range of the camera’s lens.
Note
• This feature is available to the camera administrator only.
1. Click the [Pan/Tilt Range] button in the operation bar.
2. Aim the camera to the leftmost point you want to allow to be seen, then click .
3. Aim the camera to the rightmost point you want to allow to be seen, then click .
4. Aim the camera to the uppermost point you want to allow to be seen, then click .
5. Aim the camera to the lowermost point you want to allow to be seen, then click .
6. Click [Save].
Note
• You can aim the camera by clicking on the desired navigation button, or by using the click to center
feature.
Operating Instructions 17
1.2.3 Limiting the Pan/Tilt Range
To Next Page
Loading...
