5. Under [Access Level], select the desired setting for [Video Display Time].
– [Unlimited]: The user can view video images ([MPEG-4] or [MJPEG]) from the camera without
restriction.
– [Not permitted]: The user can view only still images.
– [10 s]–[60 min]: The user can view video images for the selected amount of time, after which the user
can view only still images.
6. Select the desired setting for [Refresh Rate]. Still images viewed by the user will be refreshed at this rate.
7. Select the features the user is allowed to use.
• You can select features individually, or click [Level 1], [Level 2], or [Level 3] to enable/disable the
corresponding group of features.
8. Click [Save].
Note
• Users can click to center when using the digital zoom feature, even if the click to center feature is
disabled. Users can click to center the image within the zoomed area, but the lens will not pan or tilt.
Operating Instructions 105
6.3 General Users
To Next Page
Loading...
