• This feature cannot transfer images to web-based mail servers, such as Hotmail.
2. Enter the port number used by the server. (Port 25 is normally used for sending E-mail.)
3. Enter the reply E-mail address
*2
that will be shown to the recipient as the sender of the E-mail.
• In an effort to reduce spam, many ISPs block E-mail sent through the SMTP server from an E-mail
address that is not associated with the SMTP server, therefore, we recommend entering the E-mail
address assigned to you by your ISP.
4. Enter the destination E-mail address
*2
. Up to 3 addresses can be entered.
5. Enter the subject
*2
that will be displayed in E-mail messages sent by the camera (max. 44 characters).
6. Enter the text
*2
that will be displayed in the body of E-mail messages sent by the camera (max. 63
characters).
• Line breaks cannot be entered.
7. Under [How to authenticate], select the authentication method your ISP requires for sending E-mail, and
enter the appropriate settings if necessary.
– [No authentication]: Select this option if the outgoing E-mail server does not require authentication
when sending E-mail messages.
– [POP before SMTP authentication]: Select this option if the outgoing E-mail server requires POP before
SMTP authentication when sending E-mail messages.The following settings are also necessary. Enter
the settings as you would for receiving E-mail.
a. Enter the IP address or the host name
*1
of the POP3 server (incoming mail server).
• An IPv6 address can be entered.
b. Enter the port number used by the server. (Port 110 is normally used for POP3.)
c. Enter the login ID
*2
(user name) required to access the server (max. 63 characters).
d. Enter the password
*2
required to access the server (max. 63 characters).
– [SMTP authentication]: Select this option if the outgoing E-mail server requires SMTP authentication
when sending E-mail messages.The following settings are also necessary. Enter the settings as you
would for sending E-mail.
a. Enter the login ID
*2
(user name) required to access the server (max. 63 characters).
b. Enter the password
*2
required to access the server (max. 63 characters).
• The camera supports LOGIN, PLAIN, and CRAM-MD5 authentication.
8. Click [Save], then click [Go to Trigger page].
• All buffered images for the selected trigger are deleted when you click [Save].
*1
[Space], [“], [’], [&], [<], and [>] cannot be entered.
*2
[“] cannot be entered.
Operating Instructions 47
2.5.1 Sending Trigger Notifications by E-mail
To Next Page
Loading...
