Summary
In order to access your camera over the Internet, you need to do the following.
1. Configure your router for port forwarding. If your router supports UPnP™, this can be done automatically.
Refer to the operating instructions included with your router for information on UPnP™ support (the router’s
UPnP™ feature may be turned off by default) or for information on setting port forwarding.
2. If your ISP has assigned you a dynamic global IP address, register with a Dynamic DNS service. We
recommend using Viewnetcam.com, a Dynamic DNS service that is designed for use with Panasonic
Network Cameras. (For more information, refer to the Viewnetcam.com website at http://
www.viewnetcam.com.)
3. After you have registered with a Dynamic DNS service, configure the camera to use that service.
70 Operating Instructions
To Next Page
Loading...
