[Static]
1. Under [Network Configuration from Setup Program], select whether or not you want to allow the camera
to be configured using the Setup Program on the CD-ROM.
2. Under [Internet Connection], enter the port number to be assigned to the camera.
• The default port number is 80, however, note that some ISPs do not allow access from the Internet
using port 80. Ask your ISP or network administrator about which port numbers are available for access
over the Internet.
• Do not use the following port numbers:
– 20 and 21: used for FTP
– 23: used for Telnet
– 25: used for SMTP
– 53: used for DNS
– 110: used for POP3
– 443: used for HTTPS
– 4000: used for ICQ
– 6661–6667: used for IRC
• If you are connecting multiple cameras and plan on using port forwarding to allow Internet access to
the cameras, assign a different port number to each camera. We recommend using port numbers in
the 50000–50050 range.
3. Enter the IP address to be assigned to the camera.
Operating Instructions 83
5.1.1 Network (IPv4) Settings
To Next Page
Loading...
