149
18.1.15 Removing the Discharge Grille
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Perform “18.1.4 Removing the Control Board (Electronic Controller)”.
5 Perform “18.1.8 Removing the Indicator, Receiver & Human Sensor Control Board to below side”.
6 Perform “18.1.9 Removing the Indicator, Receiver & Human Sensor Control Board from unit”.
7 Perform “18.1.10 Removing the Electronic Controller Box and Bracket”.
8 Perform “18.1.11 Removing the nanoe Controller Box”.
9 Perform “18.1.12 Removing the Drive Motor of the Vertical and Horizontal Direction Louver (Left side)”.
10 Perform “18.1.13 Removing the Front Grille bracket (Frame - Air Filter)”.
11 Perform “18.1.14 Removing the Drive Motor of the Vertical and Horizontal Direction Louver (Right side)”.
12 Disconnect the drain hose and pull the blowout / discharge grille to remove it.
Blowout/discharge grille
18.1.16 Removing the Indoor Motor and Cross Flow Fan
1 Perform “18.1.1 Removing the Front Panel”.
2 Perform “18.1.2 Removing the Air Filters”.
3 Perform “18.1.3 Removing the Front Grille (Right) and Front Grille (Left)”.
4 Perform “18.1.4 Removing the Control Board (Electronic Controller)”.
5 Perform “18.1.8 Removing the Indicator, Receiver & Human Sensor Control Board to below side”.
6 Perform “18.1.9 Removing the Indicator, Receiver & Human Sensor Control Board from unit”.
7 Perform “18.1.10 Removing the Electronic Controller Box and Bracket”.
8 Perform “18.1.11 Removing the nanoe Controller Box”.
9 Perform “18.1.12 Removing the Drive Motor of the Vertical and Horizontal Direction Louver (Left side)”.
10 Perform “18.1.13 Removing the Front Grille bracket (Frame - Air Filter)”.
11 Perform “18.1.14 Removing the Drive Motor of the Vertical and Horizontal Direction Louver (Right side)”.
12 Perform “18.1.15 Removing the Discharge Grille”.
13 Remove the screws (2 pieces) on the left side of the heat exchanger.
Screw
To Next Page
Loading...
