- 209 -- 209 -
12. Remote Operations - Tethered Recording
1 (When connecting with a USB connection cable)
Set [USB Mode] to [PC(Tether)].
●
[MENU/SET] [ ] [ ] [USB Mode] [PC(Tether)]
(When connecting with a LAN cable)
Set the camera to DHCP server before setting it to a wired LAN connection setting.
●
[MENU/SET] [ ] [ ] [LAN / Wi-Fi] [LAN / Wi-Fi Setup] [IP Address Setting (LAN)] [DHCP Server]
●
If you changed the setting of [IP Address Setting (LAN)], turn the camera off and then on again.
● [MENU/SET] [ ] [ ] [LAN / Wi-Fi] [LAN / Wi-Fi Function] [New Connection] [Control With LUMIX
Tether]
[LAN]
(When connecting with Wi-Fi)
Set the camera to a Wi-Fi connection setting.
●
[MENU/SET] [ ] [ ] [LAN / Wi-Fi] [LAN / Wi-Fi Function] [New Connection] [Control With LUMIX
Tether] [Wi-Fi] [Via Network] / [Direct]
●
For details about [Via Network] and [Direct]. ( 231 / Wi-Fi Connections)
● Proceed to Step 3.
2 Connect the camera and PC with the USB connection cable or LAN cable.
●
At default setting, the camera is set to DHCP server. By connecting the camera directly to your PC with a LAN cable,
you can connect the camera to your PC without manually setting network information such as the IP address.
● When using PoE+ power supply with the camera, connect a PoE+ compatible switching hub and PC with a LAN cable.
3 Use “LUMIX Tether” to operate the camera from the PC.
●
(When connecting for the first time with a LAN cable or Wi-Fi)
Set a password to connect to the camera from “LUMIX Tether”. (from 8 to 31 characters)
● A tether icon is displayed in the upper right of the screen during recording standby.
To Next Page
Loading...
