Panasonic DC-BGH1 - Genlock Settings; Input a Sync Signal

- 67 -- 67 -
4. Recording Videos - Genlock settings
Genlock settings
When using several units of this camera or recording in combination with other recording devices, input the external sync signal
from the [GENLOCK IN] terminal to synchronize the cameras.
The camera is compatible with BBS (Black Burst Sync) and tri-level sync.
Input a sync signal
B
A
C
D
E
A
Camera (Slave)
B
[GENLOCK IN] terminal
C
BNC cable (commercially available)
D
Sync signal generator (Master)
E
External device (Slave)
1 Connect the sync signal generator and camera with a BNC cable.
2 Set [Genlock Input] to [ON].
●
[MENU/SET] [ ] [ ] [Genlock] [Genlock Input] [ON]
3 Output a sync signal with the sync signal generator.
●
When connecting a BNC cable to the [GENLOCK IN] terminal, use one that is less than 2.8 m (9.1 feet).
It is recommended to use a double shielded BNC cable equivalent to 5C-FB.