buttons
Numbered
buttons
TVGU DE_
ENTER
This setting allows you to select the type of television connected.
While stopped
Press [FUNCTIONS].
Press [A, V] to select "Other Functions" and
then press [ENTER].
Press [A, V] to select "Setup" and then press
[ENTER].
Press [A, V] to select "TV Screen" and then
press [1_].
Press [A, V] to select "TV Type" and then
press [ENTER].
oAspect 4:3/Aspect 16:9:
You can operate the TV through the unit's remote control.
Point the remote control at the television
While pressing [_, TV POWER] enter the code
with the numbered buttons.
e.g., 0250: [0] _ [2] _ [5] _ [0]
Manufacturer and Code No.
Panasonic 0250/0051
National
QUASAR
FISHER 0154
GE 0047
GOLDSTAR 0178/0457/0317
HITACHI 0145
JVC 0053
LG 0178/0457/0317
MAGNAVOX 0054
MITSUBISHI 0150
PHILIPS (RC-5) 0054
RCA 0047
SAMSUNG 0060/0587/0702
SANYO 0154
SHARP 0165/0093
SONY 0000
SYLVANIA 0054
THOMSON 0047
TOSHIBA 0156
ZENITH 0017
Test by turning on the television and changing channels.
• Repeat the procedure until you find the code that allows correct
operation.
• If your television brand is not listed or if the code listed for your
television does not allow control of your television, this remote
control is not compatible with your television.
Change the remote control code on the main unit and the remote
control (the two must match) if you place other Panasonic products
close together.
Use "1", the factory set code, under normal circumstances.
After performing steps 1 to 3 (4 left)
Press [A, V] to select "Setup" and then press
[t,-].
Press [A, V] to select "Remote Control Code"
and then press [ENTER].
Press [A, V] to select the code (Set Code 1,
Set Code 2, or Set Code 3) and then press
[ENTER].
• The code on the unit has been set.
4:3 standard aspect television 16:9 widescreen television
• 480p/480i:
- Select "480p" if the television is compatible with progressive
output.
- Select "480i" if the television is not compatible with
progressive output or you are unsure about television
compatibility.
Press [A, _'] to select the item and then press
[ENTER].
When connected to a 4:3 standard aspect television
To change how a DVD-Video or DVD-RAM widescreen picture is
shown on a 4:3 standard aspect television
4 77, "4:3 TV Settings for DVD-Video" or "4:3 TV Settings for
DVD-RAM"
To return to the previous screen
Press [RETURN].
While pressing [ENTER], press and hold the
numbered button ([1], [2] or [3]) for more than
2 seconds.
• The code on the remote control has been set.
Press [ENTER].
• When the following indicator appears on the
unit's display and you are unable to operate the
unit
The unit's remote control code
Press and hold [ENTER] and the indicated number button at the
same time for more than 2 seconds.
To exit the screen
Press [RETURN] several times.
RQT8346
To Next Page
Loading...
