Panasonic DMR-EH75V

DRIVE SELECT-
B|
FUNCTIONS
e.g.: Connecting other video equipment to the IN2 or DV input
terminals
You can also connect to the INlet IN3 input terminals on the
rear.
oTurn off the unit and other video equipment before connecting.
This unit
Yellow White Red i :1_
_J _ _ _ ',or',U_ Dvcable
_m_ ?' _ '_ ', ',/(IEEE 1394 4-pin)',
SVideo udi°Nide°i i/
....--!-.......! .......' :J--................'
I Other video equipment }
I I
If the audio output of the other equipment is monaural
Connect to L/MONO on the IN2 input terminals at the front.
The S-VIDEO terminal achieves a more vivid picture than the
VIDEO terminal.
When recording from the unit's DV terminal
Select the type of audio recording from "Select Audio Channel for
DV Input" in the Setup menu (4 76).
When recording from DV equipment (e.g., digital video camcorder),
you can record audio/video recordings from DV tape only.
When copying 16:9 aspect titles:
• If copying to the _ F_R_I:
set "Recording for High-Speed Copying" to "Off" and you can copy
in 16:9 aspect titles.
• If copying to [] _ _ I_JTi_:
Regardless of the "Recording for High-Speed Copying" settings,
the video will record in 4:3 aspect titles _.
You can change the screen size by adjusting the screen mode on
the television.
Note
• If it becomes time for a scheduled recording to start while copying,
the recording will start and the copying will stop.
Preparation
• Connect a video cassette recorder to this unit's input terminals.
• Press [DRIVE SELECT] to select the recording drive (HDD, DVD or
VHS).
• Press [REC MODE] to select the recording mode.
Note
• When recording using this unit's input terminals, only the sound
received at the time of recording will be recorded. As long as the
secondary audio that is recorded on the video cassette is not
output on the unit in play, it is not recorded.
While stopped
Press [INPUT SELECT] to select the input
channel for the equipment you have connected.
e.g., If you have connected to IN2 input terminals, select "IN2".
Start play on the other equipment.
When you want to start recording
Press [O, REC].
Recording starts.
Press [1_, PLAY].
• Start playing the video cassette and find the recording start
point.
Press [I I, PAUSE], then press [0, REC].
• Put the unit in recording standby mode.
Start play on the external device.
Press [I I, PAUSE] at the point where you
want to start recording.
To skip unwanted parts
Press [11, PAUSE] to pause recording. (Press again to restart
recording.)
To stop recording
Press [i, STOP].
Almost all videos and DVD software on sale have been
treated to prevent illegal copying. Any software that has
been so treated cannot be recorded using this unit.
• Using Flexible Recording (-> 30), you can save the content of a
video cassette (approx. 1to 8 hours) to a 4.7 GB disc with the best
possible quality of recording without wasting disc space.
RQT8346